Home The Garage Modifications and Repairs
  • 1
  • 2
  • 3
  • 4
Twin Stalk Indicator Cancellation Twin Stalk Indicator Cancellation Late mokes with the twin stalk indicator switch use two small pins under the steering wheel to cancel the indicators. This works fin... Read more
Rod Change Bracket to fit Exhaust Rod Change Bracket to fit Exhaust A modified bracket to support the remote on a Rod change gearbox that allows greater access for the exhaust to fit, especially extra... Read more
Raised Exhaust in Rear Subframe Raised Exhaust in Rear Subframe An example of how the exhaust and muffler were raised up into the rear subframe cavity to prevent the muffler and exhaust from being... Read more
Replacement Windscreen Washer Bottle Replacement Windscreen Washer Bottle As the Moke ages the windscreen washer bottle is something that tends to have perished on many Mokes and although new factory items ... Read more
Moke Rear Brake Line Modification Moke Rear Brake Line Modification A slightly different rear brake pipe modification for the Moke is to reroute the pipe from the wheel cylinder to the end of the shor... Read more
Moke Wiper Wiring - Secrets Revealed Moke Wiper Wiring - Secrets Revealed It seems that the Moke wiper wiring causes more headaches than the rest of the electrical system combined. So to help with restora... Read more
Replacement body shells and panels Replacement body shells and panels A common question asked on The Moke Forum is where can I get replacement panels and body shells for my Moke restoration and unfortun... Read more
The subframe bolt tyre protector. The subframe bolt tyre protector. A modification to the rear subframe of the Moke to protect the tyre from damage, getting a gapping hole torn in it, from a failed tr... Read more
Installing Jacking Rings in the rear subframe. Installing Jacking Rings in the rear subframe. A modification to the rear suspension of the Moke that raises not just the ride height but also the suspension travel and reduces th... Read more
Recycling Old Hydraulic Cylinders Recycling Old Hydraulic Cylinders New clutch and brake slave cylinders are readily available and quite cheap, but these days they are not always the best quality. And... Read more
Sloppy Gearchange? Sloppy Gearchange? A very common complaint with rod change gearboxes is the sloppy gearchange. While they will never be perfect, you certainly shouldn'... Read more
Moke Wiper Wiring - Secrets of the Twin Stalk Moke Wiper Wiring - Secrets of the Twin Stalk With the introduction of the Gal body Mokes, the old dash mounted wiper switch was replaced by a column mounted switch. Later on the... Read more


Rear Trailing Arm Hole Reinforcement

Last Updated on Sunday, 11 September 2011 20:38

Trailing Arm Washer of MokeA problem which is showing up a little more often nowadays is the ovaling of the hole in the rear subframe mount of the trailing arm. The fix might just work as the prevention and this article explains how.

Read more: Rear Trailing Arm Hole Reinforcement

 

Twin Fuel Tank Set up on Desert Storm

Last Updated on Sunday, 07 August 2011 00:09

Moke Twin Tank Fuel SystemThe Twin Fuel tank set up I have in Desert Storm is perhaps not to everyone's tastes but there might be elements of it that could help you in the design of your own twin tank system. No rear filler, electronic solenoids to control it and the mechanical fuel pump does the work moving the fuel around.

Read more: Twin Fuel Tank Set up on Desert Storm

   

Modified Engine Steady for Export 1275

Last Updated on Sunday, 07 August 2011 00:08

export moke engine steadyThe left hand Engine Steady for the '71 to '73 Export Moke is different from all other models to make way for the fitting of the Master cylinders on the left. This article shows how to modify, shorten, a standard the engine steady to suit a mismatch of the engine and firewall brackets.

Read more: Modified Engine Steady for Export 1275

   

Moke Wiper Wiring - Secrets of the Twin Stalk

Last Updated on Friday, 17 June 2011 21:32

TwinStalkTitle100With the introduction of the Gal body Mokes, the old dash mounted wiper switch was replaced by a column mounted switch. Later on the wiper motor was changed as well.This is a quick guide to how it all works.

Read more: Moke Wiper Wiring - Secrets of the Twin ...

   

Sloppy Gearchange?

Last Updated on Saturday, 24 September 2011 21:53

SloppyGearchange100A very common complaint with rod change gearboxes is the sloppy gearchange. While they will never be perfect, you certainly shouldn't be bashing your knuckles on the dash when changing gears. Most of the time it is simply due to wear, and with a bit of time and a few parts you can make a huge improvement.

Read more: Sloppy Gearchange?

   

The Donkey Telegraph

Subscribe to receive an email about Moke news from www.moke.com.au